RL V6-3.7L (2009)
Seat Cover: Service and Repair
Front Seat Cushion Cover Replacement
Front Seat Cushion Cover Replacement
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs
or service.
-
Check the operation of the driver's seat position sensor after any of these actions: See: Restraint Systems/Air Bag Systems/Testing and
Inspection/Component Tests and General Diagnostics/Driver's Seat Position Sensor Operation Check
-
Driver's seat position sensor replacement
-
Cover plate (front side of driver's seat slide rail) replacement
-
Calibrate the ODS unit after any of the these actions: See: Restraint Systems/Air Bag Systems/Testing and Inspection/Programming and
Relearning/ODS Unit Calibration
-
Front passenger's seat replacement (including any seat components)
-
Replacement of the seat weight sensors
-
After a vehicle collision
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to tear the seam or damage the seat covers.
-
Use the appropriate tool from KTC trim tool set to avoid damage when prying components.
1. Remove the front seat. See: Service and Repair/Front Seat Removal/Installation
2. Remove the screw, and release the hook (A), the tabs (B), and the pin (C), then remove the front cover (D).
3. Remove the recline cover (A).
-1 Remove the screw, and detach the clip.
Detach the tabs (B).
-3 Pull up the cover, then release the hook (C) and the tab (D).
Remove the upper inner cover (E).
-5 Disconnect the power seat adjustment switch connector (F) and the lumbar support switch connector (G).
Remove the wire harness (H) from the hooks (I).