RL V6-3.7L (2009)
6. Remove the pad shims (A) and brake pads (B).
7. Remove the pad retainers (A).
8. Clean the caliper thoroughly; remove any rust and check for grooves and cracks.
9. Inspect the brake disc for runout, thickness, and parallelism, and check for damage and cracks. See: Brake Rotor/Disc/Testing and
Inspection/Rear Brake Disc Inspection
10. Apply M-77 assembly paste (P/N 08798-9010) to the retainers on their mating surfaces against the caliper bracket indicated by arrows.
11. Install the pad retainers. Wipe excess assembly paste off the retainers. Contaminated brake discs and pads reduce stopping ability. Keep assembly
paste off the discs and pads.
12. Install the pad retainers.
13. Apply M-77 assembly paste (P/N 08798-9010) to the pad side of the shims (A), and the back of the brake pads (B) and the other areas indicated
by the arrows. Wipe excess assembly paste off the pad shims and brake pads. Contaminated brake discs or pads reduce stopping ability. Keep
assembly paste off the discs and pads.
14. Install the brake pads and pad shims on the caliper bracket. Install the inner brake pad with its wear indicator (C) facing on top.
If you are reusing the brake pads, always reinstall the brake pads in their original positions to prevent a momentary loss of braking efficiency.
