RL V6-3.7L (2009)
15. Push in the piston (A) so the caliper will fit over the brake pads. Make sure the piston boot is in position to prevent damaging it when installing the
caliper.
NOTE: Be careful when pushing in the caliper, brake fluid might overflow from the master cylinder's reservoir.
16. Apply M-77 assembly paste (P/N 08798-9010) to the piston edges (B) on their mating surfaces against the inner pad shim.
17. Install the brake caliper (C).
18. Install the caliper bolts, and torque them to the specified torque while holding the caliper pins (D) with a wrench being careful not to damage the
pin boot.
19. Clean the mating surface of the brake disc/drum and the inside of the wheel, then install the rear wheels.
20. Press the brake pedal several times to make sure the brakes work, then road-test the vehicle.
NOTE: Engagement of the brake may require a greater pedal stroke immediately after the brake pads have been replaced as a set. Several
applications of the brake pedal will restore the normal pedal stroke.
21. Add brake fluid as needed.
22. After installation, check for leaks at the hose and line joints and connections, and retighten if necessary.
