RL V6-3.7L (2009)
lathe.
Refinishing
NOTE: Refinish the brake disc with a commercially available on-car brake lathe.
1. Remove the brake caliper assembly. See: Service and Repair/Front Brake Disc Replacement
2. Install the brake lathe brackets (A) to the knuckle (B).
NOTE: Place two bolts (C) in the brackets before tightening the bolts (D).
3. Install the on-car brake lathe adapters (A) to the brake lathe bracket (B), then refinish the brake disc.
4. Measure the brake disc runout, thickness, and parallelism.
NOTE:
-
If the brake disc is beyond the service limit for refinishing, replace it. See: Service and Repair/Front Brake Disc Replacement
-
A new brake disc should be refinished if its runout is greater than 0.04 mm (0.0016 in.).