RL V6-3.7L (2009)
Brake Caliper: Service and Repair
Rear Brake Caliper Overhaul
Rear Brake Caliper Overhaul
CAUTION
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
-
Avoid breathing dust particles.
-
Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
Remove, disassemble, inspect, reassemble, and install the caliper, and note these items:
-
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
-
To prevent dripping brake fluid, cover disconnected hose joints with rags or shop towels.
-
Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
-
Before reassembling, check that all parts are free of dirt and other foreign particles.
-
Replace parts with new ones as specified in the illustration.
-
Make sure no dirt or other foreign matter gets in the brake fluid.
-
Make sure no grease or oil gets on the brake discs or pads.
-
When reusing brake pads, always reinstall them in their original positions to prevent loss of braking efficiency.
-
Do not reuse drained brake fluid. Use only clean Acura DOT 3 Brake Fluid from an unopened container. Non-Acura brake fluid can cause
corrosion and shorten the life of the system.
-
Coat the piston, piston seal groove, and caliper bore with clean brake fluid.
-
Replace all rubber parts with new ones whenever disassembled.
-
After installing the caliper, check the brake hose and line for leaks, interference, and twisting.
-
When you apply the silicone grease, make sure not to get any on the terminal part of the connectors and the surrounding switches. Also, do not
touch the switches and the terminal part of connector with hands or gloves that have silicone grease on them.
