RL V6-3.7L (2009)
NOTE: When the millimeter wave radar is adjusted on ground that has more than 1 degree of horizontal slope (drainage slope), the vertical aiming
cannot be adjusted correctly. Check the levelness of the ground, and adjust the angle of millimeter wave radar to be parallel to that of the ground, lay a
ruler (at least 12'') or other flat straight object on the ground and put the level on top to confirm the levelness of the ground.
Vertical Aiming
NOTE: When the millimeter wave radar is adjusted on ground that has more than 1 degree of horizontal slope (drainage slope), the vertical aiming
cannot be adjusted correctly. Check the levelness of the ground, and adjust the angle of millimeter wave radar to be parallel to that of the ground, lay a
ruler (at least 12'') or other flat straight object on the ground and put the level on top to confirm the levelness of the ground.
1. Remove the upper grille cover. See: Body and Frame/Grille/Service and Repair/Upper Grille Replacement
2. Put the level (A) (commercially available) on the aiming pad (B) of the millimeter wave radar.
3. Turn the vertical adjusting bolt (C) on the driver's side with a screwdriver, and adjust the angle of millimeter wave radar so that the air bubble in
the level is centered.
Horizontal Aiming
1. Park the vehicle on level ground with at least this much open space around it: 32.8 ft (10 m) in front, 13.1 ft (4 m) in width, and 4.9 ft (1.5 m) in
height.
2. Make sure there are no reflecting objects or anything in this range.
3. Check the tire pressures, and adjust the pressures to the specified value if need.
4. Put a person or an object equivalent to the driver's weight in the driver's seat.
Setting the Distance between the Target and the Vehicle Horizontal Aiming
NOTE: When marking on the floor, use suitable tape to mark the exact locations.
5. Adjust the tip of the height rod (A) on the target to the center of the front radar cover (B).
