RL V6-3.7L (2009)
Wheel Speed Sensor: Testing and Inspection
VSA System Wheel Speed Sensor Inspection
NOTE: The outer board joint must be removed to inspect the magnetic encoder.
-
Front driveshaft removal. See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Testing and Inspection
-
Rear driveshaft removal. See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Overhaul/Rear Driveshaft Disassembly
1. Clean the magnetic encoder, and make sure no metal or other debris is stuck to the magnetic encoder surface.
2. Check the magnetic encoder (A) for damage. If cracked or damaged, replace the encoder (wheel bearing).
-
Front wheel bearing replacement. See: Maintenance/Wheels and Tires/Wheel Bearing/Service and Repair/Knuckle/Hub Bearing Unit
Replacement
-
Rear wheel bearing replacement. See: Steering and Suspension/Suspension/Rear Knuckle Alignment Link/Service and Repair
3. Measure the air gap between the wheel speed sensor (B) and the magnetic encoder all the way around while rotating the encoder.
Front
Rear
