RL V6-3.7L (2009)
Cruise Control Switch: Service and Repair
Cruise Control Combination Switch Test/Replacement (Without ACC/CMBS)
Cruise Control Combination Switch Test/Replacement
There are SRS components located in this area. Review the SRS component locations, See: Restraint Systems/Air Bag Systems/Locations and the
precautions and procedures, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service
and Repair in the SRS before doing repairs or service.
1. Remove the driver's airbag. See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Driver's Airbag
Replacement
2. Disconnect the connectors, then remove the switch.
3. Check for continuity between the terminals in each switch position according to the table.
-
If there is continuity, and it matches the table, but switch failure occurred on the cruise control input test, check and repair the wire harness on
the switch circuit.
-
If there is no continuity in one or both positions, replace the switch.
4. Check for continuity between the terminals according to the table.
-
If there is continuity, and it matches the table, check and repair the wire harness on the switch circuit.
-
If there is no continuity in one or more positions, replace the switch.