RL V6-3.7L (2009)
Fan Shroud: Service and Repair
Fan, Fan Motor, and Shroud Removal and Installation
Removal
1. Remove the right side fender trim.
2. Raise the vehicle on the lift to full height.
3. Remove the splash shield. See: Engine/Service and Repair/Engine Removal
4. Remove the harness connectors (A), the ground cable (B), and the harness clamps (C).
5. Loosen the A/C condenser fan shroud mounting bolts (D).
6. Lower the vehicle on the lift.
7. Remove the air intake duct cover (A) and the coolant reservoir (B).
8. Disconnect the radiator fan control (RFC) connectors (A) and the A/C condenser fan motor connector (B), then remove the harness clamps (C).
9. Remove the radiator fan control (RFC) unit. See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry
Receiver/Service and Repair/RFC Unit Replacement