RL V6-3.7L (2009)
2. Install the crankshaft pulley, and tighten the bolt. Do not use an impact wrench.
-1 Hold the pulley with the holder handle (A) and the holder attachment (B). Tighten the bolt to 64 N-m (6.5 kgf-m, 47 lbf-ft) with a torque
wrench and a 19 mm socket (C).
-2 Mark the bolt head (D) and the crankshaft pulley (E) as shown, then tighten the bolt an additional 60 ° (The mark on the bolt head lines up
with the mark on the crankshaft pulley).
3. Install the drive belt. See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair
4. Install the splash shield.
5. Install the right front wheel.