RL V6-3.7L (2009)
1. Remove the left kick panel. See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Interior Trim Removal/Installation -
Front Door Sill Area
2. Remove PGM-FI main relay 2 (FUEL PUMP) (A) from the driver's under-dash fuse/relay box.
3. Start the engine, and let it idle until it stalls.
NOTE: If any DTCs are stored, clear and ignore them.
4. Turn the ignition switch to LOCK (0).
5. Remove the fuel fill cap to relieve the pressure in the fuel tank.
6. Do the battery terminal disconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
7. Remove the quick-connect fitting cover (A).
8. Check the fuel quick-connect fitting for dirt, and clean it if needed.
9. Place a rag or shop towel over the quick-connect fitting (A).
