RL V6-3.7L (2009)
2. Connect the knock sensor connector (A), then install the harness holder mounting bolt (B).
3. Install the injectors. See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and Repair
4. Install the intake manifold. See: Intake Manifold Removal and Installation
5. Install the P/S pump and the P/S hose clamp See: Cylinder Head Assembly/Service and Repair/Removal and Replacement/Cylinder Head
Installation
6. Inspect for fuel leaks. Turn the ignition switch to ON (II) (do not operate the starter) so the fuel pump runs for about 2 seconds and pressurizes the
fuel line. Repeat this operation three times, then check for fuel leakage at any point in the fuel line.