RL V6-3.7L (2009)
-
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
10. Set the rocker arm assembly in place, and loosely install the bolts. Make sure that the rocker arms are properly positioned on the valve stems.
NOTE:
-
Wait at least 30 minutes before filling the engine with oil.
-
Do not run the engine for at least 3 hours after installing the rocker arm assembly.
11. Tighten each bolt two turns at a time in the sequence shown to ensure that the rockers do not bind on the valves.
12. Install the injector base (A). Always use a new gasket (B).
13. Apply new engine oil to the threads of the camshaft pulley mounting bolt (A). Install the back cover (B), then install the camshaft pulley (C).
14. Set the camshaft pulleys to TDC before bolting them onto the engine block. See: Cylinder Head Assembly/Service and Repair/Removal and
Replacement/Cylinder Head Installation
