RL V6-3.7L (2009)
Air Door Actuator / Motor: Service and Repair
Mode Control Motor Replacement
Mode Control Motor Replacement
1. Remove the driver's dashboard undercover. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation
2. Disconnect the connectors (A) from the power tilt/telescopic steering control unit, the adaptive front lighting control unit, the electronically
controlled power steering control unit, and the daytime running lights control unit. Remove the relay (B) and the power tilt/telescopic steering
control unit (C), then remove the self-tapping screws and the bracket (D).
3. Remove the driver's air mix control motor. See: Driver's Air Mix Control Motor Replacement
4. Disconnect the 5P connector (A) from the mode control motor. Remove the harness clips (B). Remove the self-tapping screws and the mode
control motor (C).
5. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make
sure the motor runs smoothly.
