RL V6-3.7L (2009)
Air Bag(s) Arming and Disarming: Service and Repair
SRS Precautions and Procedures
General Precautions
Please read the following precautions carefully before servicing the airbag system. Observe the instructions described in this manual, or the airbags could
accidentally deploy and cause damage or injuries.
-
Except when doing electrical inspections, always turn the ignition switch to LOCK (0), ground the SCS line with the HDS to take the PCM out of
active status, disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
NOTE: The SRS memory is not cleared even if the ignition switch is turned to LOCK (0) or the battery cables are disconnected from the battery.
-
Use replacement parts which are manufactured to the same standards and quality as the original parts. Do not install used SRS parts. Use only new
parts when making SRS repairs.
-
Carefully inspect any SRS part before you install it.
Do not install any part that shows signs of being dropped or improperly handled, such as dents, cracks or deformation.
-
Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the SRS connector.
-
Use only a digital multimeter to check the system. If it is not a Honda multimeter, make sure its output is 10 mA (0.01 A) or less when switched to
the lowest value in the ohmmeter range. A tester with a higher output could cause accidental deployment and possible injury.
-
Do not put objects on the front passenger's airbag.
-
The original audio system and the navigation system have a coded theft protection circuit. Be sure to get the client's anti-theft codes before
disconnecting the negative cable from the battery.
-
Before returning the vehicle to the client, enter the anti-theft codes for the audio system and the navigation system.
Steering-related Precautions
Cable Reel Alignment
-
Misalignment of the cable reel could cause an open in the wiring, making the SRS system, remote steering wheel controls, and the horn
inoperative. Center the cable reel whenever the following is performed. See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral
Cable/Service and Repair
-
Installation of the steering wheel
-
Installation of the cable reel
-
Installation of the steering column
-
Other steering-related adjustment or installation
-
Do not disassemble the cable reel.
-
Do not apply grease to the cable reel.
-
If the cable reel shows any signs of damage, replace it with a new one. For example, if it does not rotate smoothly, replace the cable reel.
Airbag Handling and Storage
