RL V6-3.7L (2009)
Combination Switch: Service and Repair
Combination Light Switch Test/Replacement
1. Remove the driver's dashboard undercover, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation and the driver's dashboard lower cover. See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Driver's Dashboard Lower Cover Removal/Installation
2. Remove the steering column covers. See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering Column Removal and
Installation
3. Disconnect the combination light switch 12P connector (A) from the wiper/washer switch (B).
4. Remove the two screws, then slide out the combination light switch (A).
5. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, check for continuity between the terminals in each switch position according to the tables.
6. If the continuity is not as specified, replace the switch.