RL V6-3.7L (2009)
Auxiliary Power Outlet: Service and Repair
Rear Accessory Power Socket Test/Replacement
Rear Accessory Power Socket Test/Replacement
1. Open the center console.
2. Remove the screws and accessory trim (A).
3. Inspect the 2P connector (B) terminals to be sure they are all making good contact.
-
If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
4. Turn the ignition switch to ACC (I), and measure the voltage between terminal No. 1 and body ground. There should be battery voltage.
-
If there is battery voltage, go to step 5.
-
If there is no battery voltage, check for:
-
Blown No. 9 (20 A) or No. 32 (10 A) fuse in the driver's under-dash fuse/relay box.
-
Faulty accessory power socket relay.
-
Poor ground (G503, G601).
-
An open in the wire.
5. Check for continuity between terminal No. 2 and body ground. There should be continuity.
-
If there is continuity, go to step 6.
-
If there is no continuity, check for:
-
Poor ground (G503).
-
An open in the wire.
6. Remove the socket (A).
7. Remove the housing (A) from the accessory trim (B).
8. Install the power socket in the reverse order of removal.
