RL V6-3.7L (2009)
Transmission Position Switch/Sensor: Testing and Inspection
Transmission Range Switch Test (Without ACC/CMBS)
Transmission Range Switch Test
1. Do the battery removal procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
2. Remove the battery base.
3. Remove the air cleaner. See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair
4. Disconnect the transmission range switch connector.
5. Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each
switch position.
6. Transmission range switch test is finished if the test results are OK.
If there is no continuity between any terminals, check that the transmission range switch installation. If the switch installation is OK, replace the
switch. See: Service and Repair/Transmission Range Switch Replacement
7. Install the air cleaner. See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair
8. Install the battery base.
9. Do the battery installation procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
Transmission Range Switch Connector
