RL V6-3.7L (2009)
Pressure Regulating Solenoid: Service and Repair
A/T Clutch Pressure Control Solenoid Valve C Replacement
A/T Clutch Pressure Control Solenoid Valve C Replacement
1. Do the battery removal procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
2. Remove the air cleaner. See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair
3. Remove the battery base.
4. Disconnect the A/T clutch pressure control solenoid valve C connector.
5. Remove A/T clutch pressure control solenoid valve C.
6. Remove the ATF joint pipes, O-rings, ATF pipe, and gasket.
7. Clean the mounting surfaces and the fluid passages of the solenoid valve body and transmission housing.
8. Install the 8 x 53 mm ATF joint pipe (A) with the filter end into its mounting hole (B).
9. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and solenoid valve body mounting surface (D). The
height is about 7 mm (0.3 in.) If the height is over 7 mm (0.3 in.), push the pipe until it bottoms in the accumulator body.