RL V6-3.7L (2009)
Seat Heater Switch: Testing and Inspection
Seat Heaters Switch Test/Replacement
Front Seat
1. Remove the center console panel. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center
Console Removal/Installation
2. Disconnect the 6P connector from the seat heater switch (A).
3. Remove the two screws and the switch.
4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity is not as specified, replace the illumination bulbs (B) or the switch.
Rear Seat
1. Remove the console trim. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center Console
Armrest Removal/Installation
2. Disconnect the 6P connector from the seat heater switch (A).
3. Remove the two screws and the switch.
4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity is not as specified, replace the illumination bulbs (B) or the switch.