RL V6-3.7L (2009)
Ignition Switch: Testing and Inspection
Ignition Key Switch Test
Ignition Key Switch Test
1. Remove the driver's dashboard undercover, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation and the driver's dashboard lower cover, See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Driver's Dashboard Lower Cover Removal/Installation then remove the steering column
covers. See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering Column Removal and Installation
2. Disconnect the 10P connector (A) from the ignition switch control unit.
3. Check for continuity between terminals No. 3 and No. 6.
-
There should be continuity with the key in the ignition switch.
-
There should be no continuity with the key removed.
4. If the continuity is not as specified, replace the ignition switch control unit.
