RL V6-3.7L (2009)
Seat Position Sensor: Service and Repair
Driver's Seat Position Sensor Replacement
Removal
NOTE:
-
Removal of the driver's seat position sensor must be done according to Precautions and Procedures. See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair
-
Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.
1. Move the driver's seat all the way back, and all the way up, then tilt the seat-back all the way forward.
2. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait at least 3 minutes.
3. Remove the rear cover from the inner seat rail.
4. Disconnect the left side wire harness 2P connector (A) from the driver's seat position sensor.
5. Remove the mounting nut (B), then remove the driver's seat position sensor.
Installation
NOTE:
-
Be sure to install the harness wires so they are not pinched or interfering with other parts.
-
Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
-
After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.
1. Install the new driver's seat position sensor with a mounting nut (A), then connect the left side wire harness 2P connector to the driver's seat
position sensor (B). Reinstall the seat cover.
2. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
3. Check the operation of the driver's seat position sensor with the HDS. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Component
Tests and General Diagnostics/Driver's Seat Position Sensor Operation Check