RL V6-3.7L (2009)
Ignition Switch: Testing and Inspection
Ignition Switch Test
Ignition Switch Test
SRS components are located in this area Review the SRS component locations. See: Restraint Systems/Air Bag Systems/Locations and precautions and
procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before
performing repairs or servicing.
1. Do the battery terminal disconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
2. Remove the left front door sill trim and left kick panel. See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Interior
Trim Removal/Installation - Front Door Sill Area
3. Disconnect the 6P connector from the driver's under-dash fuse/relay box.
4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity checks do not agree with the table, replace the steering lock/switch.
6. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures