RL V6-3.7L (2009)
Auxiliary Power Outlet: Testing and Inspection
Front Accessory Power Socket Test/Replacement
Front Accessory Power Socket Test/Replacement
1. Remove the console panel, See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center
Console Removal/Installation and disconnect the 6P connector (C528) (A).
2. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 3.
3. Turn the ignition switch to ACC (I), and measure the voltage between terminal No. 4 and body ground. There should be battery voltage.
-
If there is battery voltage, go to step 4.
-
If there is no battery voltage, check for:
-
Blown No. 9 (20 A) or No. 32 (10 A) fuse in the driver's under-dash fuse/relay box.
-
Faulty accessory power socket relay.
-
An open in the WHT wire.
-
Poor ground (G601).
4. Check for continuity between terminal No. 3 and body ground. There should be continuity.
-
If there is continuity, go to step 5.
-
If there is no continuity, check for:
-
An open in the BLK wire.
-
Poor ground (G503).
5. Remove the cover (A) and disconnect the 2P connector (B) from the front accessory power socket.
6. Check for continuity between the accessory power socket subharness 6P connector (C528) terminal No. 4 and the accessory power socket 2P
connector terminal No. 1, and the 6P connector (C528) terminal No. 3 and the accessory power socket 2P connector terminal No. 2. If the harness
is OK, go to step 7.
