RL V6-3.7L (2009)
Starter Motor: Removal and Replacement
Starter Removal and Installation
Removal
1. Do the battery terminal disconnection procedure. See: Battery/Service and Repair/Procedures
2. Remove the engine cover.
3. Remove the vacuum hose (A), transmission dipstick (B), and vacuum line mounting bolt (C).
4. Remove the harness clamp (A).
5. Disconnect the starter cable (B) from the B terminal, then disconnect the BLK/WHT wire (C) from the S terminal.
6. Remove the two bolts holding the starter, then remove the starter.
Installation
1. Install the starter (A) using a new gasket (B), then install the harness clamp (C), and connect the B terminal (D) and BLK/WHT wire (E). Make
sure the crimped side of the B terminal faces away from the starter when you connect it.
