RL V6-3.7L (2009)
7. Remove and discard the valve stem (A), and the screw (B) from the tire pressure sensor (C).
NOTE: The valve stem grommet (D) might stay in the wheel; make sure you remove it.
Installation
NOTE: Use only wheels that have a "TPMS" mark (A) on them.
1. Assemble a new valve stem (A), a new screw (B), and a sensor-transmitter (C).
NOTE: Always use a new valve stem and a new screw.
2. Before installing the tire pressure sensor, clean the mating surfaces on the sensor and the wheel.
3. Install the tire pressure sensor (A) to the wheel (B), and tighten the valve nut (C) finger tight. Make sure the pressure sensor is resting on the
wheel.
4. Tighten the valve nut to the specified torque while holding the tire pressure sensor toward (D) the wheel. You may hear a snap or pop as you