RL V6-3.7L (2009)
Power Steering Pump: Removal and Replacement
Power Steering Pump Replacement
1. Place a suitable container under the vehicle.
2. Remove the right upper fender trim (A).
3. Drain the power steering fluid from the reservoir.
4. Remove the drive belt (A) from the pump pulley. See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive
Belt/Service and Repair
5. Cover the auto-tensioner, the alternator, and the A/C compressor with several shop towels to protect them from spilled power steering fluid.
Disconnect the pump inlet hose (B) and the pump outlet hose (C) from the pump (D), and plug them. Take care not to spill the fluid on the body or
parts. Wipe off any spilled fluid at once. Do not turn the steering wheel with the pump removed.
6. Cover the opening of the pump with a piece of tape to prevent foreign material from entering the pump.
7. Remove the pump mounting bolts (E), then remove the pump.
8. Connect the pump inlet hose and the pump outlet hose onto the new pump.
9. Loosely install the pump in the pump bracket with the mounting bolts, then tighten the pump fittings securely.
10. Tighten the pump mounting bolts to the specified torque.
11. Install the drive belt (A).
Note these items during belt installation:
-
Inspect the belt for wear and cracks. Replace the belt if necessary.
-
Make sure that the belt is properly positioned on the pulleys (B).
