RL V6-3.7L (2009)
7. Lower the floor jack gradually.
8. Remove the spring (A), the spring mounting cushion (B), and the lower spring seat (C).
Installation
1. Install the spring mounting cushion (A), the spring (B).
2. Align the bottom of the spring (A), the stepped part of the lower spring seat (C), and lower arm B.
3. Place the floor jack at the connecting point of lower arm B and the stabilizer link.
4. Raise the jack slowly until you can align the bolt hole of lower arm B and the knuckle ball joint pin, then loosely install a new castle nut (A).
