RL V6-3.7L (2009)
Wheels: Testing and Inspection
Wheel Runout Inspection
NOTE: When measuring the front wheel runout, turn the other side of the wheel slowly by hand.
1. Raise the vehicle, and support it with safety stands in the proper locations. See: Vehicle Lifting/Service and Repair
2. Check for a bent or a deformed wheel.
3. Set up the dial gauge as shown, and measure the axial runout by rotating the wheel.
4. Reset the dial gauge to the position shown, and measure the radial runout.
5. If the wheel runout is not within the specification, check the wheel bearing end play, See: Wheel Bearing/Testing and Inspection and make sure
the mating surfaces on the brake disc and the inside of the wheel are clean.
6. If the bearing end play is within the specification but the wheel runout is more than the service limit, replace the wheel.