RL V6-3.7L (2009)
17. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and solenoid valve body mounting surface (D). The
height is about 7 mm (0.3 in.) If the height is over 7 mm (0.3 in.), push the pipe until it bottoms in the accumulator body.
18. Install the new gasket (A) on the transmission housing, and install the 8 x 34.5 mm ATF joint pipe (B) with the filter end into the transmission
housing and 8 x 25.2 mm ATF pipe (D).
19. Install new O-rings (E) over the ATF joint pipes.
20. Install A/T clutch pressure control solenoid valve C.
21. Check the connector for rust, dirt, or oil, then connect the connector securely.
22. Install the air cleaner. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair
23. Install the battery base.
24. Do the battery installation procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
