RL V6-3.7L (2009)
15. Remove the A/T clutch pressure control solenoid valves A and B, ATF pipes (C), gasket (D), and O-rings (E).
16. Check the fluid passage of the solenoid valve for contamination.
17. Connect a jumper wire from the negative battery terminal to A/T clutch pressure control solenoid valve B connector terminal No. 2, and connect
another jumper wire from the positive battery terminal to connector terminal No. 1. Make sure A/T clutch pressure control solenoid valve B
moves.
18. Disconnect one of the jumper wires, and check valve movement at the fluid passage in valve body mounting surface. If the valve binds or moves
sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valves A and B.
19. Clean the mounting surface and fluid passage of the solenoid valve body and solenoid valve cover.
20. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install new O-rings over the ATF pipes.
21. Install A/T clutch pressure control solenoid valves A and B.
22. Install the harness cover on its bracket, and secure it with the bolt.
23. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
24. Apply molybdenum grease to the hole in the bushing in the shift cable end. Attach the shift cable end to the control lever, then insert the control
pin into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
25. Secure the shift cable bracket with the nuts.
26. Install the battery base.
27. Install the air cleaner. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair
