RL V6-3.7L (2009)
Fluid - A/T: Service and Repair
ATF Replacement
ATF Replacement
NOTE: Keep all foreign particles out of the transmission.
1. Warm up the engine to normal operating temperature (the radiator fan comes on), and turn the engine off.
2. Raise the vehicle on a lift, or apply the parking brake, block both rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
3. Remove the splash shield.
4. Remove the ATF filler bolt and drain plug (A), and drain the automatic transmission fluid (ATF).
NOTE: If a cooler cleaning is done, refer to ATF Cooler Cleaning. See: Service and Repair/Procedures/ATF Cooler Cleaning
5. Reinstall the drain plug with a new sealing washer (B).
6. Refill the transmission with the recommended fluid through the filler hole (A). Always use Acura ATF-Z1 Automatic Transmission Fluid (ATF).
Using a non-Acura ATF can affect shift quality.
7. Install the ATF filler bolt (B) and a new sealing washer (C).
8. Check the ATF level. See: Service and Repair/Procedures/ATF Level Check
