RL V6-3.7L (2009)
Fluid Pressure Sensor/Switch: Service and Repair
4th Clutch Transmission Fluid Pressure Switch Replacement
4th Clutch Transmission Fluid Pressure Switch Replacement
1. Do the battery removal procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
2. Remove the air cleaner. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair
3. Disconnect the 4th clutch transmission fluid pressure switch connector, and remove the switch.
4. Install the new 4th clutch transmission fluid pressure switch (A) and a new sealing washer (B), and tighten the switch.
5. Make sure there is no water, oil, dust, or foreign particles inside the connector.
6. Connect the connector securely.
7. Install the air cleaner. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair
8. Do the battery installation procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
