RL V6-3.7L (2009)
15. Push the locknut against the transmission housing to seat the transmission range switch into the control shaft, and tighten the locknut (A) to 12
N-m (1.2 kgf-m, 8.7 lbf-ft) while holding the control shaft (B) with a 6.0 mm wrench (C), then bend the lock tabs (D) of the lock washer against
the locknut.
16. Tighten the bolts (E) securing the transmission range switch to 12 N-m (1.2 kgf-m, 8.7 lbf-ft).
17. Install the control lever (A), spring washer (B), lock washer (C), and locknut (D) on the control shaft (E).
18. Check the connectors for rust, dirt, or oil, clean, then connect the connector securely.
19. Apply molybdenum grease to the hole in the bushing in the shift cable end. Attach the shift cable end to the control lever, then insert the control
pin into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
20. Secure the shift cable bracket with the nuts.
21. Install the battery base.
22. Install the air cleaner. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair
23. Do the battery installation procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
24. Turn the ignition switch ON (II). Move the shift lever through all positions, and check the transmission range switch synchronization with the A/T
gear position indicator.
25. Check that the engine starts in P and N, and does not start in any other shift lever position.
26. Check that the back-up lights come on when the shift lever is in R.
27. Raise the vehicle on a lift, allow all four wheels to rotate freely, then start the engine, and check the shift lever operation.