RL V6-3.7L (2009)
Drive/Propeller Shaft: Testing and Inspection
Propeller Shaft Inspection
Universal Joint and Boots
1. Shift the transmission to the N position.
2. Raise the vehicle on a lift.
3. Check the center support bearing (A) for excessive play or rattle. If the center support has excessive play or rattle, replace the propeller shaft
assembly.
4. Check the universal joint boots for damage and deterioration. If the boots are damaged or deteriorated, replace the propeller shaft assembly.
5. Check the universal joints for excessive play or rattle. If the universal joints have excessive play or rattle, replace the propeller shaft assembly.
Propeller Shaft
1. Inspect the surface of propeller shaft No. 1 and No. 2 for damage. If there is damage, replace the propeller shaft assembly.
2. Inspect the alignment (A) of the No. 1 propeller shaft, especially if the vehicle has been in a collision. If there is difference in alignment, replace
the propeller shaft assembly.
Propeller Shaft Runout
1. Install a dial indicator with its needle on the center of the No. 1 propeller shaft or the No. 2 propeller shaft.
2. Turn the other propeller shaft slowly and check the runout. Repeat this procedure for the other propeller shaft.
3. If the runout on either propeller shaft exceeds the service limit, replace the propeller shaft assembly.