RL V6-3.7L (2009)
Axle Shaft Assembly: Overhaul
Front Driveshaft Reassembly
Front Driveshaft Reassembly
Exploded View
Special Tools Required
-
Boot band tool, KD-3191 or equivalent, commercially available
-
Boot band pincers, Kent-Moore J-35910 or equivalent, commercially available
-
Boot band pliers, commercially available
NOTE: Refer to the Exploded View, as needed, during this procedure.
Inboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent damaging the inboard boot.
2. Install the inboard boot onto the driveshaft, then remove the vinyl tape. Be careful not to damage the inboard boot.
