RL V6-3.7L (2009)
8. Pack the outboard joint (A) with the remaining joint grease included in the new joint boot set.
Total grease quantity
9. Fit the boot ends (A) onto the driveshaft (B) and the outboard joint (C). Bleed any excess air from the boot by inserting a flat-tipped screwdriver
between the boot and the joint.
10. Inspect the length (A) of the driveshafts to the figure as shown, then adjust the boots to halfway between full compression and full extension.
11. Close the ear portion (A) of the band with commercially available boot band pincers, Kent-Moore J-35910 or equivalent (B).