RL V6-3.7L (2009)
Axle Shaft Assembly: Overhaul
Intermediate Shaft Reassembly
Intermediate Shaft Reassembly
Exploded View
Special Tools Required
-
Driver handle 07749-0010000
-
Base attachment, 70 mm 07LAF-SM40300
-
Base, 73 x 78/82.6 mm 07965-SD90100
-
Oil seal driver attachment, 58 mm 07JAD-PH80101
-
Fork seal driver, 39.2 mm 07947-4630100
-
Fork seal driver, 46.2 mm 07TMD-MAC0100
NOTE: Refer to the Exploded View, as needed, during this procedure.
1. Clean the disassembled parts with solvent or brake cleaner, and dry them with compressed air.
NOTE: Do not wash the rubber parts with solvent or brake cleaner.
2. Press a new intermediate shaft bearing (A) into the bearing support (B) using the driver handle (C), the 58 mm oil seal driver attachment (D), and a
press.
3. Install the internal snap ring (A) in the groove (B) of the bearing support.