RL V6-3.7L (2009)
Locking tab type
3. Install the steel balls (A) and the bearing retainer (B) onto the bearing race (C) by aligning the marks (D) on the bearing retainer and the bearing
race.
4. Install the bearing onto the driveshaft (E) by aligning the marks on the bearing and the driveshaft.
5. Install the snap ring (F).
6. Pack the inboard joint with the joint grease included in the new inboard boot set.
Grease quantity
7. Install the inboard joint onto the driveshaft by aligning the marks (A) on the inboard joint and driveshaft.