RL V6-3.7L (2009)
19. Bend the band end (A) by tapping it down with a hammer.
NOTE:
-
Make sure the band and the clip do not interfere with anything, and the band does not move.
-
Clean any grease remaining on the surrounding surfaces.
20. Repeat step 12 through 19 for the band on the other end of the boot.
21. Install a new locking tab type boot band on the inboard joint side of the inboard boot. Fold down the locking tabs.
22. Lightly tap on the doubled-over portions to flatten them.
Outboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent damaging the outboard boot.
2. Install a new ear clamp band (B) and the outboard boot, then remove the vinyl tape. Be careful not to damage the outboard boot.