RL V6-3.7L (2009)
7. Check the alignment of the paint mark (A) you made with the outboard joint end (B).
8. Pack the outboard joint (A) with the remaining joint grease included in the new outboard boot set.
9. Fit the boot ends (A) onto the driveshaft (B) and the outboard joint (C) grooves. Bleed any excess air from the boots by inserting a flat-tipped
screwdriver between the boot and the joint.
10. Inspect the length (A) of the driveshafts to the figure as shown, then adjust the boots to halfway between full compression and full extension.
