RL V6-3.7L (2009)
4. Remove the two washers (A).
5. Remove the wheel speed sensor (A) and the O-ring (B) from the knuckle. Do not disconnect the wheel speed sensor connector.
6. Raise the stake (A), and remove the spindle nut (B).
7. Remove the brake disc/drum. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Rear Brake Disc
Replacement
8. Remove the hub bearing unit (A).
9. Install the hub bearing unit in the reverse order of removal, and note these items:
-
Tighten all mounting hardware to the specified torque values.