RL V6-3.7L (2009)
10. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust or dirt, and clean the passage.
11. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install the new O-rings over the ATF pipes.
12. Install A/T clutch pressure control solenoid valves A and B.
13. Install the harness cover on its bracket, and secure it with the bolt.
14. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
15. Apply molybdenum grease to the hole in the bushing in the shift cable end. Attach the shift cable end to the control lever, then insert the control
pin into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
16. Secure the shift cable bracket with the nuts.
17. Install the battery base.
18. Install the air cleaner. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair
19. Do the battery installation procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
