RL V6-3.7L (2009)
25. Install shift solenoid valve B (brown connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the
accumulator body.
26. Connect the harness terminals to the solenoids:
-
YEL wire connector to shift solenoid valve A.
-
GRN wire connector to shift solenoid valve C.
-
RED wire connector to shift solenoid valve B.
-
ORN wire connector to shift solenoid valve D.
27. Install the shift solenoid valve cover, dowel pins, and a new gasket.
28. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with their filter side into the transmission
housing. Install new O-rings over the ATF pipes.
29. Install A/T clutch pressure control solenoid valves A and B.
30. Install the harness cover on its bracket, and secure it with the bolt.
31. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
32. Apply molybdenum grease to the hole in the bushing in the shift cable end. Attach the shift cable end to the control lever, then insert the control
pin into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
33. Secure the shift cable bracket with the nuts.
34. Install the battery base.
35. Install the air cleaner. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair
36. Do the battery installation procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
