RL V6-3.7L (2009)
Front Door Window Regulator: Service and Repair
Front Door Glass and Regulator Replacement
NOTE: Put on gloves to protect your hands.
1. Remove these items:
-
Door panel See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front Door Panel
Removal/Installation
-
Plastic cover See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Handle/Front Door Exterior Handle/Service and
Repair
-
Door sash outer trim
-
Remove the door pull pocket bracket See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and
Repair/Front Door Pull Pocket Bracket Replacement
2. Carefully raise the glass (A) until you can see the bolts through the oval holes in the door, then remove them. Carefully pull the glass out through
the window slot. Take care not to drop the glass inside the door.
3. Disconnect the connector (A) from the regulator (B).
4. Remove the bolts (C), and loosen the bolts (D), then remove the regulator through the hole in the door.
5. Apply multipurpose grease to the sliding surfaces of the regulator (A) where shown.
6. Install the glass and the regulator in the reverse order of removal, and note these items:
