RL V6-3474cc 3.5L (1998)
Connector - Index (Part 2)
3. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, make the following input tests at the connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, the control unit must be faulty; replace it.
NOTE:
-
Before testing, go to the Troubleshooting Guide. Be sure to go through self-diagnosis function modes l and 2.
-
All connector views are from the wire side of female terminals unless otherwise noted.
Multiplex Control Unit (Door):
1. Remove the driver's door panel, and disconnect the 20P connector from the door unit.
