RL V6-3474cc 3.5L (1998)
Rear Bumper: Service and Repair
Rear Bumper
Removal
CAUTION: Put on gloves to protect your hands.
NOTE:
-
An assistant is helpful when removing and installing the rear bumper.
-
Take care not to scratch the rear bumper and body.
-
To remove the rear bumper beam, remove the rear trim panel and trunk side trim.
-
'96 - 98 models: When reinstalling the rear bumper molding, replace the adhesive tape.
-
'96 - 98 models: Before reinstalling the rear bumper molding, clean the rear bumper bonding surface with a sponge dampened in alcohol.
Installation is the reverse of the removal procedure.
NOTE: If necessary, replace any damaged clips.
