RL V6-3474cc 3.5L (1998)
Paint: Description and Operation
Repair Materials and Tools
Repair Materials and Tools
The following materials and tools are required to resin bumpers:
Adhesive and Filler (examples):
-
Bumper primer (clear type)
-
Bond quick mender
-
High art mat black
-
High art thinner
-
High art hardener
Primer surfacer (examples).
-
Dual-liquid type bumper primer surfacer (gray) Reference (Isam Paint)
-
Pigment:(1kg) (35.3 oz)
-
Hardener: (100g) (3.5 oz)
-
Thinner:(900 ml)(30.4fl. oz, 31.7 Imp. oz)
NOTE: Follow the manufacturer's recommendations
Tools:
-
Putty knife
-
Brush
-
Sandpaper
-
Cutter
-
Base (putty)
-
Masking tape
-
Masking paper
1. Bumper Primer (Clear): Premixed type
The primer provides a good support for the filler and primer surfacer. It is applied to the surface of the bumper.
2. PUTTY BOND QUICK MENDER
After the PP primer has dried thoroughly, apply the PUTTY BOND QUICK MENDER.
1. Mix one part of the mender (A) and one part of the hardener (B) and stir thoroughly.
NOTE: Do not mix the mender and hardener in excess of 20g (0.7oz) at a time.
2. Hardening starts immediately after mixing.
Practical hardness will be obtained within 60 minutes. The surface will be tacky within 5 minutes and nearly hardened after 15 minutes. It takes
12 hours for the surface to harden thoroughly 68 degrees F (20 degrees C)
3. Sanding can be done after:
3. Primer Surfacer
NOTE: Use a dual-liquid type bumper primer surfacer (gray).
-
The primer surface is used to protect the PP resin surface and to fill cavities or flaws in the intermediate and top coats.
-
Mix 10 parts of primer surfacer and 1 part of hardener. Add the specific thinner (30-60%) to the mixture of the hardener and primer to attain
the proper viscosity for spraying.
4. Intermediate and Top Paint Coats (Body color)
