RL V6-3474cc 3.5L (1998)
Hydraulic Assembly: Service and Repair
Removal/installation
NOTE:
-
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
-
Take care not to damage or deform the brake lines during removal and installation.
-
To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.
Removal
1. Disconnect the pressure sensor 3P connector.
2. Pull the locking lever of the VSA control unit 42P connector up, then disconnect the connector.
3. Disconnect the six brake lines.
4. Remove the two 8 mm nuts.
5. Remove the VSA modulator-control unit.
Installation
1. Install the VSA modulator-control unit, then tighten the two 8 mm nuts.
