RL V6-3474cc 3.5L (1998)
10. Apply grease to the points indicated by the arrows in the illustration:
-
Piston end and inner shim B contact surface
-
Inner shim A contact surface (both sides)
-
Pads and caliper bracket contact surface
-
Outer pad and caliper body contact surface
-
Outer pad shim and outer pad contact surface
-
Outer pad shim and caliper body contact surface
NOTE:
-
Use the pad grease included in the pad set or Molykote M77 grease, and apply a thin coat of grease evenly to the designated points.
-
'96,'97,'99,'00 and '01 models shown.
11. Install the brake pads and pad shims correctly.
WARNING:
-
When rousing the pads, always reinstall the brake pads in their original positions to prevent loss of braking efficiency.
-
Contaminated brake discs or pads reduce stopping ability. Keep grease off the discs and pads.
NOTE: Install the pad with the wear indicator on the inside.
12. Push in the piston so that the caliper will fit over the pads. Make sure the piston boot is in position to prevent damaging it when pivoting the
caliper down.
13. Pivot the caliper down into position. Hold the caliper pin with a wrench, being careful not to damage the pin boot. Install the caliper bolt with
another wrench, and tighten it.
CAUTION: Be careful not damage the pin boot when pivoting the caliper down.
